By Drywall damage is a big problem. There are several reasons why drywall is damaged. These include temperature changes, humidity, and structural issues. If your drywall is damaged, it is important to repair the damage as soon as possible. Whether you need a quick fix or a complete replacement of your drywall, a drywall repair professional can help.
When a hole appears in your drywall, you can repair it by removing the drywall and replacing it with a new section of drywall. Typically, you will need to cut a piece of drywall the size of the damaged area. You will then need to apply a new coat of paint. Once the paint has dried, you will need to sand the damaged area smooth. This process can be done with a sanding sponge or a drywall knife.
A common cause of holes in drywall is doors that swing open too hard. Kids and toys can also poke holes in drywall. Another common cause of holes is furniture. Scuff marks from furniture can be easily removed with a damp sponge.
To repair small holes, you can use joint compound. You should apply the joint compound at a 70-degree angle. Do not remove the compound beyond the crack. The compound should be painted with the same color as the wall. Be careful to wear protective goggles and gloves. When the damage is to big and you don’t have any knowledge in repairing a drywall its nest to leave the job to professional craftsmen.
For larger holes, you will need a metal wire mesh. The mesh must be flexible enough to fit the hole. However, if the hole is larger than the mesh, you will need to bend the mesh. You can use a putty knife to push the filler into the mesh. Afterward, the patch should be sanded until it is level with the wall. It will take a few days for the patch to dry.
You can also use spackle to repair drywall. Spackle is a gypsum-based compound that can be dragged across the damaged area. Make sure to wear protective goggles and a dust mask. Before you begin, you should check for wiring and pipes that may be underneath the hole.
Before you start fixing the drywall, you will need to locate the studs behind the damaged area. The studs are the areas where most wires should be attached. Use a stud finder to locate the studs. Next, you will need to pull all the exposed drywall nails from the wall.
Then, you will need to apply a thin layer of drywall compound. Remember to sand the compound smooth. If you are using an all-purpose drywall compound, you will probably have to sand it more than if you used lightweight drywall compound. Lightweight drywall compound dries quicker.
You can also use a drywall saw to cut the drywall without destroying the studs. But be careful not to cut the studs too far. As you do, you will need to stop removing the drywall at a stud that is not farther than the damaged area.
You can also use a stud finder to locate the location of the drywall nails. If you have trouble locating the studs, you can use an electronic stud finder.